Updated November 2026
The staples hyken ergonomic chair is a mesh-back task chair built for long stretches at a desk. By the end of this guide, you will know how to set it up correctly, how to check whether its adjustments fit your body, and which mistakes to avoid so you get the support you paid for rather than a sore back by Thursday.
What You Need Before You Start
A proper setup takes about 15 to 20 minutes and needs very little equipment. Gather these before you begin:
Shopping for one? See our guide: 6 Best Staples Essentials Ergonomic Fabric Swivel Task Chairs (2026): Our Picks.
- A tape measure, to check your seat height and the distance from the seat edge to the back of your knees.
- Your regular work shoes, since footwear changes your effective height.
- Your keyboard, mouse and monitor already in their usual positions.
- The chair’s assembly manual, so you can locate the height lever, seat depth control, lumbar adjustment and armrest settings.
Step 1: Assemble and Position the Chair Correctly
Assemble the base, gas cylinder and casters first, then attach the seat and back. Tighten every bolt by hand before using a tool, which helps prevent cross-threading. Place the chair where it can roll freely without hitting a cable, file drawer or doorframe. A clear area of roughly 30 inches around the chair keeps you from twisting awkwardly to reach things.
Step 2: Set Seat Height So Your Feet Sit Flat
Seat height matters more than almost any other adjustment. Sit all the way back in the chair and raise or lower the seat until:
- Your feet rest flat on the floor, or on a footrest if you need one.
- Your thighs are roughly parallel to the floor, with knees near or slightly below hip level.
- Your elbows bend at about 90 degrees when your hands rest on the keyboard, with forearms level or angled slightly down.
If your desk is too high even at the lowest seat setting, the answer is a lower desk or a footrest, not a chair that sits you higher and leaves your shoulders hunched.
Checking the Height Against Your Desk
Once the seat is set, check the relationship between the keyboard and your elbows. Your shoulders should stay relaxed rather than lifted. If you find yourself raising your shoulders to reach the keys, the desk is probably too high for your current seat setting.
Step 3: Adjust Seat Depth
Seat depth determines how much of the cushion supports your thighs. Slide the seat forward or back so that there is a gap of about two to three finger-widths between the front edge of the seat and the back of your knees. If the seat is too deep, you will feel pressure behind the knee and your circulation will suffer. If it is too shallow, your thighs will be unsupported and you will slump.
Step 4: Set Lumbar Support
The lower back curve, or lumbar region, should be supported at the level of your belt line or just above it. Adjust the lumbar height first, then the depth, until the curve of the backrest fills the natural inward curve of your lower back. You should feel gentle support, not a push forward. Most people find the lumbar setting needs a small revisit after a week of use.
Backrest Recline and Tension
Set the recline tension so the chair rocks back with modest effort and holds you where you stop. Keep recline locked or lightly tensioned during focused work, and let it open up during calls or reading. Many users find that a slight recline, roughly 100 to 110 degrees between seat and back, reduces pressure on the spine compared with sitting bolt upright.
Step 5: Position the Armrests
Armrests should support your forearms without lifting your shoulders. Set them so that your forearms rest lightly on the pads while your shoulders stay down. The armrest should be low enough that your elbow stays close to your side when you type. If the arms bump into the desk, lower them or move them slightly outward, or remove them if the design allows.
Step 6: Check Monitor and Keyboard Position
A correct chair is only half the setup. Place the top of your monitor at or just below eye level, roughly an arm’s length away. Keep the keyboard close enough that your wrists stay in a neutral position without bending upward or downward. If you use a laptop for long periods, a separate keyboard and an external monitor make a larger difference than any chair adjustment.
Factors That Affect Fit
Body size and work habits change what counts as a good setup. Use this table as a quick reference when deciding which adjustments to prioritize.
| Factor | What to Check | Typical Adjustment |
|---|---|---|
| Height | Feet flat, thighs near parallel | Seat height lever |
| Leg length | Gap behind knees | Seat depth slider |
| Lower back | Support at belt line | Lumbar height and depth |
| Upper body | Relaxed shoulders | Armrest height and width |
| Work style | Frequent reclining or upright tasks | Recline tension |
Common Mistakes
- Leaving the chair at factory settings. Default positions rarely match a specific body. Adjust every control at least once.
- Sitting too far forward. Pushing hips to the front edge removes back support and strains the lower spine.
- Raising the seat to reach a high desk. This pushes elbows and shoulders upward. Fix the desk height or add a footrest instead.
- Ignoring the armrests. Armrests set too high cause shoulder tension over a full day.
- Making one-time adjustments and walking away. Revisit the setup after a few days and again after any change in your desk or work routine.
- Expecting the chair to fix posture alone. Movement breaks matter. Stand, walk or stretch at least once an hour.
Tips for Getting the Most From the Chair
- Keep a short notebook of your settings for a week so you can return to the best combination quickly.
- Use a small footrest if your feet dangle when the seat height is right for your desk.
- Spend five minutes each morning checking that the seat height and lumbar support have not drifted, since some controls loosen with use.
- Pair the chair with the desk stretches described in our guides on sitting and movement for a fuller routine.
Recommended gear
These items help with setup and comfort once the chair is adjusted. Choose the ones that match your desk and work habits.
- A footrest. Useful when your desk height forces your thighs to slope downward. A stable footrest with an adjustable angle lets you keep your knees at hip level. View on Amazon
- A monitor riser. Raises the screen so the top sits near eye level and your neck stays neutral. View on Amazon
- An external keyboard and mouse. Lets you position input devices at elbow height, which matters more than most chair tweaks for wrist and shoulder comfort. View on Amazon
Related Reading
If you are still deciding whether this model suits your space, start with our overview in Hyken Ergonomic Mesh Swivel Task Chair: Setup and Buying Guide (2026). For comparisons with other Staples models, see 7 Best Staples Ergonomic Task Chair Picks for Every Desk (2026) and 5 Best Staples Ergonomic Desk Chair Picks for Every Home Office (2026). Readers with a smaller frame may also find Petite Ergonomic Desk Chair: 5 Best Picks for Small Frames (2026) useful.
FAQ
Is the staples hyken ergonomic chair suitable for all-day sitting?
It can be, provided you set the seat height, depth, lumbar support and armrests correctly and take movement breaks. No chair eliminates the need to change position during the day.
How do I know if the seat depth is right?
Sit back fully and check for a gap of about two to three finger-widths between the seat edge and the back of your knees. If you feel pressure there, the seat is too deep.
Should the lumbar support sit high or low?
Position it at the level of your belt line or just above it, where your lower back naturally curves inward. Adjust until it feels supportive without pushing you forward.
Do I need to use the armrests?
Use them if they help you keep your shoulders relaxed. If they force your shoulders up or hit the desk, lower them, move them outward or remove them.
How often should I readjust the chair?
Check the setup after a few days of use and again whenever your desk, footwear or work routine changes. Small drifts are normal.
What if my feet do not reach the floor?
Use a footrest. Adjusting the seat higher to reach the floor usually raises your elbows above the keyboard, which creates shoulder strain.
Can a chair alone fix back pain?
A well-adjusted chair can reduce strain, but it is not a treatment. If you have persistent or worsening back pain, consult a doctor or physical therapist for guidance tailored to your situation.
Conclusion
Setting up the staples hyken ergonomic chair comes down to a clear order: seat height, seat depth, lumbar support, recline tension and armrests, then desk and monitor alignment. Work through each adjustment, check your posture after a few days, and revisit the settings as your work changes. A patient, methodical setup will do far more for your comfort than any single feature.

